SUOMY SR Sport - Manual (Page 28)

Verify that the part was assembled correctly by checking that:
- the cheek pad is firmly locked in position
- that the strap is completely free inside the hole and was not blocked under the cheek pad
during assembly.
Only the correct assembly of the cheek pad and the correct positioning of the strap will
assure the proper operation of the retention system. During use, the locking lever must
always be fixed in lock position; if it cannot be locked correctly do not use the helmet.
CHEEK PADS – Removing the fabric lining
Removing the cheek pads:
The lining is fitted over the polystyrene shell without adhesives or other mechanical fastening
methods. To remove it just slide it out of its seat and stretch out the elastic closing edge on the back
part.
Fitting the pads:
Fit the lining on the padding starting from one of the ends, and then fit it on the opposite side.
Verify that the lining is correctly applied to the padding so that it fits tightly without folds.
26
Eng USE and MAINTENANCE
figure 8
B
E
A
F
D C
X
Y