Thermo Fisher Scientific CyberScan DO 600 - Manual (Page 21)

13
TEXT – Select this format if you use any other method
(such as Windows
®
Hyperterminal)
This parameter is used when downloading data from
the meter through IrDA
Current Data
Set
TIMED – Prints measurement data continuously at the
interval specified in ‘INTERVAL’ parameter below.
SINGLE – Prints only the currently measured reading
This parameter applies when PRIN key is pressed from
measurement mode to send the currently measured
readings to the computer.
TIMED
Interval
(3 Sec Step)
Time interval at which the meter should send currently
measured data to the printer/CyberComm/PCD
Acceptable range : 3 sec to 600 sec (in 3 sec steps)
(This parameter is applicable when ‘CURRENT DATA
SET’ is set to ‘TIMED’ and this is not editable when
‘CURRENT DATA SET’ is set to ‘SINGLE’)
9 Sec
Fixed Setting Indicates serial communication settings in the format of
‘Baud rate, Data bits-Parity bits-Stop bits’. This
parameter is not editable.
2400 8-N-1
System Settings Page 5 – Password Protection
This allows you to enable password protection for the setup mode & calibration
mode:
Figure 6: System Settings Page 5 – Password Protection
When you enable password protection, the meter prompts you to enter the password
whenever you try to access the Setup or Calibration mode. The meter does not allow
you to edit setup parameters or perform a new calibration unless you enter the
correct password. If an incorrect password is entered for 3 consecutive times, the
meter goes to measurement mode.
Parameter Description Factory Default
Password
Protection
ENABLE – Sets password protection for the setup &
calibration mode. If this is enable you need to specify
DISABLE