West Control Solutions 9500 - Manual (Page 16)

16
Function Sub-functions Settings [Factory settings] shown
in brackets
Press ▲ or ▼ to change Press ✱ ▲ or ✱ ▼ to change
TyPE Define segment type SPr Ramp to next target setpoint
SPrr [100] Setpoint ramp rate Units per
hour/minute (0-9990) (as set at
Spru above)
t.SP (Segment target setpoint)
adjustable over instrument’s
configured range
hb.u Hold back [oFF] sets the
permitted band size for the
measured value to deviate from
the ramp setpoint before the
program is ‘held back’ waiting for
the measured value to catch up.
(0.1 to 150 units)
SoAK Hold setpoint for pre-set time [10]
Sint Soak time, adjust in minutes
(cont.-1440) x 0.1
StEP Step to new target setpoint (Set
tSP as above)
LooP Re-cycle program
PCYC [1] Set number of program loops
up to 999, or continuous loop
CALL Call up another program by
number to import into this
program
Sub.P (nonE) Number of Program called
at
Call above
Edit dEL Delete segment
Edit inS Insert new segment
❋
❖
†
†
FUNCTION LIST (LEVEL P) PROGRAMMER
LEVEL P
Access Level P from Level 1. Press and hold ✱ ▼
Function Settings [Factory settings] shown in brackets
Press ▲ or ▼ to change Press ✱ ▲ or ✱ ▼ to change
ProG Program number [1] Add new programs (1 to 31)
run Run Program [oFF] Program not running
on Run program
hoLd Pause program
Edit dEL Delete program
Edit inS Insert new program
Edit CoPy Copy another program
Edit PStE Paste copied program
Fail Power failure recovery mode [rSEt] Reset to program start
Cont Continue from interruption
hoLd Hold at interruption (User re-start)
St.V Program start value [PV] Process value
SP Setpoint value
SPru Ramp rate time units [hour] Ramp rate adjust in hours
60 s Ramp rate adjust in minutes
SEG Segment number [1] Add new segments (1 to 126)
❋
❖
†
†
†
†
See examples of EDIT procedures (page 18)
Deleting a Program automatically re-numbers those programs with higher numbers
Until memory full. See page 11 for further explanation and memory allocation table
on page 17.
❋
LEVL P
❖
†
English