Safety and warranty information, Safety and warranty, English – West Control Solutions 9500 User Manual

Page 23

Advertising
background image

SAFETY AND WARRANTY INFORMATION

INSTALLATION

Designed for use:
UL873 - only in products where the acceptability is determined by Underwriters Laboratories
Inc.
EN61010-1 / CSA 22.2 No 1010.1 - 92
To offer a minimum of Basic Insulation only.
Suitable for installation within Catagory II and III and Pollution Degree 2.

SEE ELECTRICAL INSTALLATION Page 19

It is the responsibility of the installation engineer to ensure this equipment is installed as
specified in this manual and is in compliance with appropriate wiring regulations.

CONFIGURATION

All functions are front selectable, it is the responsibility of the installing engineer to ensure that
the configuration is safe. Use the program lock to protect critical functions from tampering.

ULTIMATE SAFETY ALARMS

Do not use SP2/SP3 as the sole alarm where personal injury or damage may be caused by
equipment failure.

WARRANTY

CAL Controls warrant this product free from defect in workmanship and materials for three (3)
years from date of purchase.
1 Should the unit malfunction, return it to the factory. If defective it will be repaired or

replaced at no charge.

2 There are no user-servisable parts in this unit. This warranty is void if the unit shows

evidence of being tampered with or subjected to excessive heat, moisture, corrosion
or other misuse.

3 Components which wear, or damage with misuse, are excluded e.g. relays.
4 CAL Controls shall not be responsible for any damage or losses however caused, which

may be experienced as a result of the installation or use of this product.

CAL Controls liability for any breach of this agreement shall not exceed the purchase
price paid E. & O.E.

Copyright CAL Controls Ltd. 2000

Not to be reproduced without prior written permission from CAL Controls Ltd. Whilst
every effort has been made to ensure the accuracy of the specifications contained in
this manual, due to our policy of continuous development, CAL Controls Ltd reserves
the right to make changes without prior notice.

CUSTOMER FEEDBACK

It is CAL Controls aim to provide the best possible service to our customers. Feedback
from our customers is therefore very important to ensure that we can make continual
improvements to our products and services. Should you wish to register any issues with
CAL please e-mail us at [email protected] or via the ‘contact us’ section of our
web site at www.cal-controls.co.uk. Title your e-mail comments as ‘Registered customer
feedback’ or ‘Registered customer complaint’.

Alternatively you can contact us on tel: +44 (0)1462 436161 or fax: +44 (0)1462 451801

23

English

Advertising