West Control Solutions KS 94 - Manual (Page 29)

10.8 ALARM: alarms
10.8.1 Alarm 1 / (limit 1)
The function for alarm 1, (output via output OUT 4) is configured.
Main configuration:
Src Fnc Dp
(Alarm signal source) (Alarm function)
(Decimals for alarm
limits)
00: no source
01: Xeff
02: Xw*
03: x1
04: x2
05: x3
06: auxiliary
variable z
07: Wext
08: {w
09: Weff
10: Yp
11: Ypid
12: OVC
13: WMIN/MAX (Wsel)
14: INP1
16: INP3
17: INP4
18: INP5
19: INP6
20: program time (net)
21: program time (gross)
22: program rest time
23: Status PROFIBUS-DP
24: faulty actor
0: no alarm (don’t care)
1: sensor fail
2: sensor fail or measurement
value alarm
3: sensor fail or measurement
value
alarm with suppression with
set-point switch-over or
start-up
4: measurement value alarm
5: measurement value alarm with
suppression with set-point
change
or start-up
6: Bus error (PROFIBUS-DP)
0: no decimal point
1: 1 digit behind the
decimal point
2: 2 digits behind the
decimal point
3: 3 digits behind the
decimal point
*Limit comparator (refered to set-point), all other versions are fitted with limit contact.
10.8.2 Alarm 2 (limit 2)
The function for alarm 2 (output via OUT 5) is configured.
Main configuration C.620
see
C.600
10.8.3 Alarm 3 (limit 3)
The function for alarm 3 (output via OUT 1) is configured.
Main configuration C.640
see
C.600
Selection is possible with OUT1 configured as alarm output.
10.8.4 Alarm 4 (limit 4)
The function for alarm 4 (output via OUT 2) is configured.
Main configuration C.660
see
C.600
Selection is possible only with OUT2 configured as alarm output
Configuration
4 31 Operating instruction KS9
C.600
ALRM1
Alarm 1
00.0.0