West Control Solutions KS 94 - Manual (Page 34)

11. Parameters
11.1 General
This section gives a survey of the KS92/94 parameter data and general hints for parameter handling.
The parameter operation and effect on the controller operation are described with the operating
principle.
The parameter setting dialogue is realized via selector key M and ‘increment’ / ‘decrement’ keys
ID, like at the other operating levels:
w Press the selector key to select menu items / input values within one level and to change to the next
higher level.
w Press the ‘increment’ / ‘decrement’ keys to return to a lower level or to change input values.
The controller parameter structure is given on the following page. All parameters are listed.
Parameters which are not relevant for a function (configuration-dependent) are not displayed!
A selection menu can be displayed anywhere at parameter level by pressing key M >3s.
End: return to parameter level
Mark: mark the selected parameter for
display at ‘extended’ configuration level.
Exit: return to operating level.
Conf: transition to configuration level.
11.1.1 Allocation of parameters to the ‘extended operating level’
Up to 12 parameters can be allocated to the ‘extended operating level’ (see Fig.3: ), whereby the
controller operation is simplified, since changing over to parameter level whenever one of these
parameters must be changed is omitted.
Allocation: select required parameter, press
‘selection’ key M during >3s (Para blinks)
Select Mark with ‘up’ key I and acknowledge with
‘selection’ key M (see Fig.3: ).
Delete: select the required parameter at the extended
operating level, press ’selection’ key M during >3s
(Para blinks) and acknowledge with ’up’ key I.
Select Clear and acknowledge with ‘selection’
key M (see Fig.4: ).
Hold: The Hold function can be used for selecting
a parameter from the extended operating level for
being visible continuously. For this, select the
required parameter at the extended operating level,
press ‘selection’ key M during >3s (Para blinks)
select Hold with ‘up’ key I and confirm with
’selection’ key M (see Fig.4:).
Applications:
w During optimization, frequent access to defined parameters (Xp1, Xp2, Tn and Tv) is required.
w During commissioning, limit value ( LimH1, LimH2, ...) or measurement value corrections must be
changed frequently.
w
With the parameter level disabled, access to the selected parameters is possible for the operator.
Deleting a parameter from the ‘extended operating level’ must be done at this level (see Fig.4: )
Parameters
Operating instruction KS94 36
Fig.4: deleting a parameter
Fig.3 : selecting a parameter