Audient ASP4816 - Compact Analogue Recording Console - Manual (Page 17)

Page -17- © Audient Ltd
Glossary
Flip
Flip allows the inputs to the signal paths to be swapped. Normally the LF path will carry the DAW
input, however, with FLIP pressed it will carry the MIC/LINE input while the DAW input will travel
through the SF path.
Foldback
Foldback is a mix that is returned to the performers in the studio in order that they can play in time
with what is already recorded. It could simply be the console stereo output although more usually it
is taken from a pair of auxiliary buses allowing a different mix to be created. Talkback may also be
included on the foldback outputs enabling communication with the artists.
In-line
This refers to a type of console which contains two signal paths within a channel stip. The channel
signal path is used to feed a DAW or other recording device while the monitor path is used to carry
the output of the DAW (or other recording device) through to the stereo mix bus. In-line consoles can
be more compact than split consoles or can carry more channels for a given size. The possibility of
switching signals between the two paths and of sharing facilities between the paths makes the in-line
concept a very attractive one.
Insert points
Insert points allow the signal path to be broken allowing the insertion of some signal processing de-
vice. The device inserted is then in series with the signal path. When not required the device can either
be switched out using the INSERT switch or unplugged from the console.
LF
The Long fader is normally used to feed the mix. The lighter areas of the channel strips are areas used
for the LF signal path. There may be a dark switch labelled SF allowing that facility to be switched
into the SF or short fader path.
Line
The line input is a high level, high input impedance input intended for high level sources such as the
outputs of a DAW or other recording device, sampler etc.
Mic
The microhone input is a low level, low impedance input intended for use by low output devices such
as microphones. This contrasts with the line input which is intended for use by equipment with high
output levels, such as a DAW line output for example.
Mix
This allows signal to be routed to the stereo mix bus which is the main output of the console. This rout-
ing can be applied to both the SF and LF signal paths and is particularly useful during mix down when
as many inputs as possible are often required.