Audient ASP4816 - Compact Analogue Recording Console - Manual (Page 6)

Page -6- © Audient Ltd
Service and Repair
The console uses a complex internal pcb sandwich arrangement making field service only possible by
a qualified technician. If any technical issues do arise with your console, please contact your dealer as
soon as possible to arrange for technical support. Do not attempt to fix the console unless qualified to
do so. See the warranty section provided at the end of this manual for details of your cover.
However, if you do need to access the inside of the console, the mechanical design allows for easy
entry. If you do need to access the inside of the console for any reason please power down the device
and disconnect the IEC power cord before proceeding.
All audio path PCBs are panel mounted to the control surface, with the I/O connector PCBs mounted
to the rear of the chassis base. The switch mode power supply, and power distribution PCB are mount-
ed to the chassis base. PCBs are linked via ribbon cables or small cable runs. As such the console can
be opened without stress or strain on internal wiring or components.
4 x M6 bolts located underneath the armrest allow this to be lifted off. The control surface module is
also held in place with 4 M6 bolts located on the underside of the chassis. Once these are removed the
control surface module can be hinged up using the hand hold cut-outs in the front surfce of the mod-
ule. (just like a car bonnet!). A 45cm long prop is recommended to support the control-surface module,
freeing both hands for whatever issue you may be attempting to solve!
Ventilation
Care should be taken not to obstruct the series of ventilation holes in the metalwork of the console.
The desk is designed to release heat and take adequate air flow via these holes to ensure longevity of
performance. These are located underneath the armrest, in the sides of the console and meterbridge.
If mounting the console into some form of studio furniture or desk, please ensure a sufficient air gap at
these locations.
Lexan overlay
The front panel of the ASP4816 features a rugged under-surface printed polycarbonate overlay. Expo-
sure to direct sunlight for extended periods of time should be avoided as this can have a detrimental
effect on the overlay panel and the control knobs. However at least the panel legending will not wear
off like some of the silk screened or engraved products of yesteryear!
Power-up
On power up, please check that the power rail indicators for +48v d.c
and +/-18v d.c light on the right hand side of the console.
Introduction.