Kaman 8000 Enclosures - Manual (Page 40)

40
3)
Pull off the switch cap and pop off the front of the meter panel using a small flat
head screwdriver and twisting slightly in the slot near the bottom center of the
panel.
Note: The DIP switch may either be a rocker type (press down on
appropriate end) or a slider type (slide toward appropriate
end). The drawing in fig. 26 details the adjustment
activities.
fig. 26 -- MCD 8000 Adjustment Switches;
4) Actual calibration occurs in the SCALING mode. Push down or slide towards
the bottom the left most dip switch. This will put the unit in scaling mode and
the word "LO" will appear on the display.
fig. 27 -- Process/Scaling Dip Switch;