PEP Filters SMF2-FG User Manual

Page 12

Advertising
background image

SMF2-FG Series Media Filter

Operating & Maintenance Manual

PEP Filters

• 322 Rolling Hill Road • Mooresville, NC 28117 • 800-243-4583 •

www.pepfilters.com

704-662-3133 (Outside USA) Page 11 of 16 Fax 704-662-3155

rev. 01/02

1. O-ring or gasket for filter tank access port, hand hole and manhole gaskets.

2. O-ring seal or gasket for pump pre-strainer lid (if applicable).

3. Seal kit for pump

4. Transformer fuse (automatic units only).

SAFETY PRECAUTIONS

All electrical, mechanical and rotating machinery constitute a potential hazard, particularly

for those not familiar with its design, construction, and operation. Accordingly, adequate

safeguards (including use of protective enclosures when necessary) should be taken with

this equipment both the safeguard the public (including minors) from injury and to prevent

damage to the equipment, its' associate system and the premises
Equipment operation, maintenance and repair should be undertaken by qualified

personnel. All such personnel should be thoroughly familiar with the equipment, the

associated system and controls, and the procedures set forth in this manual. Proper care,

procedures, and tools must be used in handling, lifting, installing, operating, maintaining,

and repairing this equipment, to prevent personal injury and/or property damage.
For the protection of authorized service and maintenance personnel, the pump motor

associated with this equipment should be installed with a lockable disconnect switch

located in close proximity and within sight if the Industrial Water Filter. No service work

should be performed on or near the pump motors, without first ensuring that the pump

motor has been electrically disconnected and locked out.
The re-circulating water system may contain chemicals or biological contaminants that

could be harmful if inhaled or ingested. Accordingly, personnel who may be exposed

directly to the mists produced by water jets or compressed air (should these be used to

clean portions or components of the Industrial Water Filter) should wear half-face

respirators with HEPA filter cartridges, NIOSH/MSHA approved number TC-21C-142/TC-

21C-18.

Advertising