State GTS-110-NI - Manual (Page 5)

Safety Guidelines
5
│
Page

Water temperatures over 125°F (52°C) can cause severe burns instantly or death
from scalding. The water temperature is set at 122°F (50°C)
from the factory to
minimize any scalding risk. Before bathing or showering always check the water
temperature.

Do not store or use gasoline or other flammables, vapors, or liquids in the vicinity
of this appliance.

Do not reverse the water and/or gas connections as this will damage the gas
valves and can cause severe injury or death. Follow the diagram on p. 20 when
installing your water heater.

Do not use this appliance if any part has been in contact with or been immersed
in water. Immediately call a licensed plumber, a licensed gas fitter, or a
professional service technician to inspect and/or service the unit if necessary.

Do not disconnect the electrical supply if the ambient temperature will drop
below freezing. The Freeze Prevention System only works if the unit has electrical
power. The warranty will not be covered if the heat exchanger is damaged due to
freezing. Refer to the section on the Freeze Prevention System on p. 35 for more
information.
SAFETY GUIDELINES
SAFETY DEFINITIONS
Indicates an imminently hazardous situation which, if not avoided, will result in
death or serious injury.
Indicates an imminently hazardous situation which, if not avoided, could result
in death or serious injury.
Indicates an imminently hazardous situation which, if not avoided, could result
in minor or moderate injury.
GENERAL
1. Follow all local codes, or in the absence of local codes, follow the most recent edition of the
National Fuel Gas Code: ANSI Z223.1/NFPA 54 in the USA or CAN/CSA B149.1 Natural Gas, Propane
Installation Code in Canada.
2. Properly ground the unit in accordance with all local codes or in the absence of local codes, with
the National Electrical Codes: ANSI/NFPA 70 in the USA or CSA standard C22.1 Canada Electrical
Code Part 1 in Canada.
3. Carefully plan where you intend to install the water heater. Please ensure:
 Your water heater will have enough combustible air and proper ventilation.
 Locate your heater where water leakage will not damage surrounding areas (please refer
to p. 7).
4. Check the rating plate for the correct GAS TYPE, GAS PRESSURE, WATER PRESSURE and ELECTRIC
RATING.
*If this unit does not match your requirements, do not install and consult with the manufacturer.
5. If any problem should occur, turn off all hot water taps and turn off the gas. Then call a trained
technician or the Gas Company or the manufacturer.
WARNING
CAUTION
DANGER
WARNING