Timeguard SLFM360 - Manual (Page 4)

3
Parts included
• PIR Sensor unit.
• Instruction manual. Please keep safe for future
reference.
• Accessory Pack. Includes wiring cover, 2 x cable
clamps, 4 x clamp screws and 1 x lens mask sticker.
Tools and parts needed
• 3 core flexible cable.
• Electric/hand-held drill & bits.
• 75mm or 3 inch diameter hole cutter.
• Terminal or Electricians screwdriver.
• Small philips screwdriver.
• Wire cutters.
• Suitable mains interconnect cable.
This product is suitable for indoor use only. Connected
load must not exceed maximum 2000W filament/
incandescent or 500W fluorescent/low energy lighting.
Do not attempt to install if you are suffering from
nausea or dizzy spells or on medication with similar
side effects. If in any doubt, consult a qualified
electrician.
Not suitable for use with discharge lighting.
Selecting a location
The motion detector has a number of detection zones,
at various vertical and horizontal angles as shown (see
diagram A).
A moving human body needs to cross/enter one of
these zones to activate the sensor. The best all-round
coverage is achieved with the unit mounted at the
SLFM360_Instruct_art_2.2.qxd 3/5/06 10:05 am Page 3