UEi Test Instruments KM940 - Manual (Page 23)

- 23 -
6. PRINTING INFORMATION
Supplied as accessories for the KANE940 are an infra-red thermal printer or a dot matrix
serial printer. Read the manual supplied with each printer prior to operation. Connections to
the KANE940 are detailed below :
• Infra-red thermal printer - this does not require a cable to transmit the data but uses an
infra-red (IR) link similar to a TV remote control. The IR emitter is positioned on the top
of the KANE940 and the bottom of the printer. Ensure they are pointing at each other and
within 300 mm, with no obstructions in the way. Data may be lost if transmission is
interrupted. Keep the KANE940 pointing at the printer until the printout has finished.
• Dot matrix serial printer - requires the supplied serial cable to transmit data. Connect the
cable to the 8 pin DIN socket on the top of the KANE940 and the 25 pin D-connector on
the printer.
Data can either be printed from a ‘live’ test or from stored data. Printing of stored data is
detailed in STORING AND RETREIVING DATA.
6.1 Printing a ‘Live’ Test
During a combustion test the KANE940 will print data on request. With the analyser showing
the MAIN DISPLAY press and current data will be sent to the printer.
The display will show the following until data transmission is complete.
∗∗∗∗∗
Printing
∗∗∗∗∗
6.2 Standard Printout
The standard printout is shown below :-