Brother PT-P700 - Manual (Page 15)

Raster Command Reference
- 11 -
2. Print Data
Descriptions for the numbers in the print data on the previous page are provided in the following table.
For details on each command, refer to “ 4. Printing Command Details ”.
No. Command Name Description
１ Invalidate A 100-byte invalidate command is sent.
2 Initialize The “initialize” command is sent.
3
Switch dynamic
command mode The printer is switched to raster mode.
Send this command before sending raster data to the printer.
4
Job ID setting
commands
Internal specification commands
Since this is a command for outputting with the commercial
version driver, it is unnecessary for the user to send this
command.
5
Print information
command Media size information for the print data is sent.
This is the c
ommand for “24 mm” tape.
6
Various mode settings
(1Bh+69h+4Dh+00H)
This is a command for specifying a mode.
Here, nothing is specified.
7
Advanced mode
settings
This is the command for specifying settings for the advanced
mode.
In this case, “no chain printing” is enabled.
8 Specify margin amount
Specifies the amount of the margins.
This is the command for “15 dots”.
9
Select compression
mode
TIFF compression mode is selected.
10 Raster data Raster data continues.
11 Print command
Since it is not the last page, the print command is sent at the end
of the page.
12
Switch dynamic
command mode The printer is switched to raster mode.
Send this command before sending raster data to the printer.
13
Job ID setting
commands
Internal specification commands
Since this is a command for outputting with the commercial
version driver, it is unnecessary for the user to send this
command.
14
Print information
command Media size information for the print data is sent.
This is the command for “24 mm” tape.
15
Various mode settings
(1Bh+69h+4Dh+00H) This is a command for specifying a mode.
Here, nothing is specified.
16
Advanced mode
settings
This is the command for specifying settings for the advanced
mode.
In this case, “no chain printing” is enabled.
17 Specify margin amount
Specifies the amount of the margins.
This is the command for “15 dots”.
18 Select compression TIFF compression mode is selected.