Brother PT-P700 - Manual (Page 41)

Raster Command Reference
- 37 -
4. Printing Command Details
g Raster graphics transfer
ASCII: g {n1} {n2} {d1} ... {dk}
Hexadecimal: 67 {n1} {n2} {d1} ... {dk}
Description
 Transfers the specified number of bytes (k) of data.
 The data is expanded by overwriting from the position where the margin was added.
 If the expanded data does not reach the end of the expansion buffer, the remainder is filled with 0 data.
 If the expanded data exceeds the end of the expansion buffer, the excess is cut off.
Parameters
{n1}{n2} Specified number of bytes k = n1 + n2*256
0000h ≦ Specified number of bytes k ≦ First positive number that exceeds the value
of the number of print head pins divided by 8 (Gauss number)
{n} Number of bytes of raster data (d1 to dk)
However, use the following value if no compression is specified as the compression mode.
PT-H500/P700/E500：n=16
{d1~dn} Raster data.
Z Zero raster graphics
ASCII: Z
Hexadecimal: 5A
Description
 Fills raster line with 0 data.
FF Print command
ASCII: FF
Hexadecimal: 0C
Description
 Used as a print command at the end of pages other than the last page when multiple pages are printed.