ADC 70 - Manual (Page 14)

ADCP-80-524 • Issue 1 • November 2001
Page 14
©
2001, ADC Telecommunications, Inc.
1.14 Fused Equipment Designation Card and Holder
Two
fuse designation cards, shown in
Figure 8 ,
and a card holder with a clear plastic cover are
provided
with the fuse panel. The card holder may be attached to the fuse panel, the fuse panel
mounting
brackets, to the rack, or a location close to the fuse panel. One of the cards may be
filled
out with circuit information for each of the circuits and inserted in the card holder. The
card
holder has a pressure sensitive adhesive backing for attachment. Additional fused
equipment
designation cards, card holders, and plastic covers can be ordered from ADC if
required.
Figure 8. Fuse Designation Cards
1.15 Voltage Designation Label
A
voltage designation label, shown in
Figure 9 ,
is provided with the fuse panel. The label may
be
filled out with the actual voltage present on the buses and placed on the panel. The voltage
designation
label has a pressure sensitive adhesive backing for attachment.
Figure 9. Voltage Designation Label
1.16 Material and Finish
The
fuse panel chassis and brackets are made of 16-gauge cold rolled steel. The panel and
brackets
are finished with powder paint.
1.60 IN.
(4.06 CM)
2.36 IN.
(5.99 CM)
12486-C
1.60 IN.
(4.06 CM)
2.36 IN.
(5.99 CM)
20 POSITION CARD 10 POSITION A AND B CARD
0.38 IN.
(0.96 CM)
1.00 IN.
(2.54 CM)
14228-A