Brother PR-620 620C 600II 600IIC - Manual (Page 11)

9
ENGLISH
b Securely clamp the mounting bracket onto
the mounting surface, and then tighten the
thumb screw.
1
Mounting bracket
2
Mounting surface (worktable, desk, etc.)
3
Tighten the thumb screw.
c Check that the mounting jig is secure.
If the mounting jig is not firmly secured to the
mounting surface, re-attach the mounting jig
and tighten the thumb screw.
Note
● Make sure that the mounting bracket is
securely clamped onto the mounting
surface and that the thumb screw is firmly
tightened.
● Do not attach the mounting jig to an
unstable surface (flexible, bent or warped).
● Be careful that the cylinder frame mounting
jig does not fall when it is removed.
Installing the cylinder frame
Hoop the fabric in the cylinder frame, and then
attach the cylinder frame to the cylinder frame
driver.
■ Hooping the fabric in the cylinder frame
a Attach the cylinder frame to the cylinder
frame mounting jig.
Align the notch in the cylinder frame with the
guiding plate on the cylinder frame mounting
jig. Hold the frame horizontal with the
mounting jig and push the frame in until it
snaps into place.
1
Guiding plate on cylinder frame mounting jig
2
Notch in cylinder frame
3
Mounting jig holder
X The cylinder frame is secured with the two
holders.
a
b
c
a b
c