Brother PR-620 620C 600II 600IIC - Manual (Page 7)

5
ENGLISH
Fabrics
For best results, it is recommended to use the
following types of fabrics.
• 100% cotton
• 35% cotton/65% polyester
• 80% wool/20% nylon
• 15% wool/85% acrylic
Fabrics that are difficult to hoop, wrinkle easily or
shrink are not recommended to be used with the
cylinder frame. Fabrics such as:
• Polyester foam
• Stretch fabrics
• Melton wool
• 100% nylon
• Suede
Note
● Patterns that misalign easily should not be
embroidered using this cylinder frame.
● Only use one-point embroidery patterns or
letters on ribbed knit fabrics.
Preparing to use the cylinder
frame
■ Installing the cylinder frame driver
Remove the embroidery frame holder from the
carriage, and then install the cylinder frame
driver.
Memo
● Before removing the embroidery frame
holder, remove the embroidery frame. For
details on the removal procedure, refer to
“Removing the embroidery frame” in the
Operation Manual.
a Loosen and remove the two thumb screws,
and then remove the embroidery frame
holder.
1
Thumb screws
2
Embroidery frame holder
• The removed thumb screws remain attached
to the embroidery frame holder.
1
Leave the two thumb screws attached so they
are not lost.
2
Embroidery frame holder
b Remove the two upper thumb screws of the
cylinder frame driver, and then loosen the
two lower thumb screws.
1
Upper thumb screws (smaller)
2
Lower thumb screws (larger)
1
2
1 2
a
b