Brother PR-620 620C 600II 600IIC - Manual (Page 8)

6
c Pass the machine bed through the ring of the
cylinder frame driver.
1
Machine bed
2
Gap in the mounting plate
Note
● Be careful that the cylinder frame driver
does not hit any nearby parts, such as the
presser foot or the gap in the mounting
plate.
d Insert the two thumb screws at the bottom
of the cylinder frame driver into the notches
in the carriage, and then place the mounting
plate of the cylinder frame driver on top of
the X carriage.
1
Notch in the carriage
2
Thumb screw of the cylinder frame driver
3
Mounting plate of the cylinder frame driver
4
X carriage
e Insert the pins on the X carriage into the
holes in the mounting plate of the cylinder
frame driver.
1
Pins on the X carriage
2
Holes in the mounting plate of the cylinder
frame driver
f Tighten the two thumb screws removed in
step
b
.
g While pushing in the cylinder frame driver
so that it is fully inserted, tighten the two
lower thumb screws to secure the cylinder
frame driver.
X This completes the installation of the
cylinder frame driver.
Memo
● Using the disc-shaped screwdriver included
with the embroidery machine, firmly tighten
the thumb screws.
b
a
a
b
c
d
1
2