For a wireless network – Brother MFC-685CW User Manual
Page 32
Configuring your machine for a wireless network
24
3
Using the SecureEasySetup™ or AOSS™ software to configure your machine
for a wireless network
3
The SecureEasySetup™ or AOSS™ software allows you to configure the wireless network easier than
configuring it manually. By pushing a button on the wireless router or access point, you can complete setup
and secure the wireless network. Your router or access point must also support SecureEasySetup™ or
AOSS™. See the user’s guide for your wireless LAN router or access point for instructions on how to use the
SecureEasySetup™ or AOSS™ mode.
Note
Routers or access points that support SecureEasySetup™ or AOSS™ have the SecureEasySetup™ or
AOSS™ symbol as shown below.
a
Push the SecureEasySetup™ or AOSS™ button on your wireless router or access point. See the user’s
guide for your wireless router or access point for instructions.
b
Press Menu on the control panel of the Brother machine.
c
Press a or b to select LAN.
Press OK.
d
Press a or b to select WLAN.
Press OK.
e
Press a or b to select SecurEasySetup or AOSS.
Press OK.
f
The wireless network connection status using the SecureEasySetup™ or AOSS™ software will be
displayed; Connecting WLAN, Setting AOSS or Connecting AOSS.
Wait till either Connected or Connection Error (Connection Fail) is displayed.
Connected is displayed when the print server is successfully connected to your router or access point.
You can now use your machine in a wireless network.
Connection Error (Connection Fail) is displayed when the print server has not successfully
connected to your router or access point. Try starting from a again. If the same message is displayed
again, reset the print server back to the default factory settings and try again.