Brother MFC-685CW - Manual (Page 92)

Control panel setup
84
6
/etc/inetd.conf file, so you may need to enable it by removing the “#” in front of the bootp entry in that file. For
example, a typical bootp entry in the /etc/inetd.conf file would be:
#bootp dgram udp wait /usr/etc/bootpd bootpd -i
Note
Depending on the system, this entry might be called “bootps” instead of “bootp”.
In order to enable BOOTP, simply use an editor to delete the “#” (if there is no “#”, then BOOTP is already
enabled). Then edit the BOOTP configuration file (usually /etc/bootptab) and enter the name, network type
(1 for Ethernet), Ethernet address and the IP address, subnet mask and gateway of the print server.
Unfortunately, the exact format for doing this is not standardized, so you will need to refer to your system
documentation to determine how to enter this information (many UNIX
®
systems also have template
examples in the bootptab file that you can use for reference). Some examples of typical /etc/bootptab entries
include: (“BRN” below is “BRW” for a wireless network.)
BRN008077310107 1 00:80:77:31:01:07 192.189.207.3
and:
BRN008077310107:ht=ethernet:ha=008077310107:\
ip=192.189.207.3:
Certain BOOTP host software implementations will not respond to BOOTP requests if you have not included
a download filename in the configuration file; if this is the case, simply create a null file on the host and specify
the name of this file and its path in the configuration file.
As with rarp, the print server will load its IP address from the BOOTP server when the printer is powered on.
DHCP mode
6
Dynamic Host Configuration Protocol (DHCP) is one of several automated mechanisms for IP address
allocation. If you have a DHCP server in your network (typically a UNIX
®
, Windows
®
2000/XP or Windows
Vista™ network) the print server will automatically obtain its IP address from a DHCP server and register its
name with any RFC 1001 and 1002 compliant dynamic name services.
IP Address
6
This field displays the current IP address of the machine. If you have selected a BOOT Method of Static, enter
the IP address that you wish to assign to the machine (check with your network administrator for the IP
address to use). If you have selected a method other than Static, the machine will attempt to determine its IP
address using the DHCP or BOOTP protocols. The default IP address of your machine will probably be
incompatible with the IP address numbering scheme of your network. We recommend that you contact your
network administrator for an IP address for the network the unit will be connected on.
a Press Menu.
b Press a or b to select LAN.
Press OK.
c (For Wired) Press a or b to select Wired LAN.
(For Wireless) Press a or b to select WLAN.