Brother NC-7100W - Manual (Page 115)

10 - 8 TROUBLESHOOTING
2 If the configuration page prints but you cannot print documents,
try the following.
a Check to see if there is any LED activity.
The Brother wireless print server has two LEDs (as shown in
Figure 10-1.)
Figure 10-1
If none of the following steps are successful, there is almost
certainly a hardware or network problem!
LEDs Status
POWER
LED TX/RX
LED Status
Ad-hoc mode Infrastructure mode
Off Off The printer’s power switch is turned off.
On Off N/A Not linked to Access
Point
Blinking
synchronously Active Linked to Access Point
TX/RX LED
POWER LED