Brother NC-7100W User Manual
Page 116
TROUBLESHOOTING 10 - 9
b
If you are using TCP/IP:
Try pinging the print server from the host operating system
command prompt with the command:
ping ipaddress
Where
ipaddress
is the print server IP address (note that in
some instances it can take up to two minutes for the print
server to initialize.
c
If you are using a Novell
®
system:
Verify that the print server can be seen on the network. To do
this, login as the SUPERVISOR (not as someone with
supervisor privileges) or ADMIN (for NetWare
®
4 or later
servers), go into PCONSOLE or NWADMIN, select PRINT
SERVER INFORMATION, and select the name of the print
server (make sure that you have entered the print server
name). If you can see
Print Server Status and
Control
in the menu, then the Brother print server is visible
to the network, proceed to the Novell
®
NetWare
®
Installation
Troubleshooting Section.
d
If you are running AppleTalk
®
for Macintosh
®
:
Make sure that you can see the print server name in the
Printer List when you select AppleTalk in the Print Center.
If it is visible, then the connection is good, so proceed to
AppleTalk