Brother MFC 9970CDW - Manual (Page 38)

Configuring your machine for a wireless network (For MFC-9560CDW and MFC-9970CDW)
33
3
For Touchscreen models
3
a Press MENU.
b Press Network.
c
Press WLAN.
d
Press a or b to display WPS w/PIN Code, and then press WPS w/PIN Code.
e
The LCD will show an 8 digit PIN and the machine starts searching for an access point for 5 minutes.
f
Using a computer that is on the network, type “http://access points IP address/” into your
browser.
(Where “access point’s IP address” is the IP address of the device that is used as the
Registrar
1
.) Go to the WPS (Wi-Fi Protected Setup) setting page and input the PIN which the LCD
shows in e to the Registrar and follow the on-screen instructions.
1 The Registrar is normally the WLAN access point / router.
Note
The setting page is different, depending on the brand of access point / router. See the instruction manual
supplied with your access point / router.
Windows Vista
®
/Windows
®
7
3
If you are using your computer as a Registrar, follow these steps:
Note
• To use a Windows Vista
®
or Windows
®
7 computer as a Registrar, you need to register it to your network
in advance. See the instruction manual that came with your WLAN access point / router.
• If you use Windows ® 7 as a Registrar, you can install the printer driver after the wireless configuration by
following the on-screen instructions. If you want to install the full driver and software package, follow the
steps in Quick Setup Guide for installation.