Brother MFC 9970CDW - Manual (Page 48)

Control panel setup
43
5
Ethernet (wired network only)
5
Ethernet link mode. Auto allows the print server to operate in 100BASE-TX full or half duplex, or in 10BASE-T
full or half duplex mode by auto negotiation.
Note
If you set this value incorrectly, you may not be able to communicate with your print server.
Status (For DCP-9055CDN, DCP-9270CDN, MFC-9460CDN and
MFC-9465CDN)/Wired Status (For MFC-9560CDW and MFC-9970CDW)
5
This field displays the current wired network status.
Setup Wizard (wireless network only)
5
The Setup Wizard guides you through the wireless network configuration. (For more information, see the
Quick Setup Guide or Using the Setup Wizard from the control panel on page 17.)
WPS or AOSS™ (wireless network only)
5
If your WLAN access point/router supports either Wi-Fi Protected Setup (PBC
1
) or AOSS™ (Automatic
Wireless mode), you can configure the machine easily without a computer. (For more information, see the
Quick Setup Guide or Using WPS or AOSS™ from the control panel menu to configure your machine for a
wireless network (Automatic Wireless mode) on page 17.)
1 Push Button Configuration
WPS w/PIN Code (wireless network only)
5
If your WLAN access point/router supports Wi-Fi Protected Setup (PIN Method), you can configure the
machine easily without a computer. (For more information, see Using the PIN Method of Wi-Fi Protected
Setup on page 31.)
WLAN Status (wireless network only)
5
Status
5
This field displays the current wireless network status.
Signal
5
This field displays the current wireless network signal strength.