Adjust the tilt foot – Acoustic Energy LT35 User Manual
Page 29
21
2
LAMP
ST
AT
US
PO
WER
SO
UR
CE
AU
TO
A
DJ
.
FO
CU
S
ON
/S
TA
ND
B
Y
SE
LEC
T
1
3
3. Projecting an Image (Basic Operation)
Adjust the Tilt Foot
1. Lift the front edge of the projector.
CAUTION:
Do not try to touch the ventilation outlet during Tilt Foot adjustment
as it can become heated while the projector is turned on and during
its cool down period after it is turned off.
2. Push and hold the Adjustable Tilt Foot Button on the front of
the projector to extend the adjustable tilt foot (maximum height).
3. Lower the front of the projector to the desired height.
4. Release the Adjustable Tilt Foot Button to lock the adjustable
tilt foot.
There is approximately 10 degrees (up) of adjustment for the front of
the projector.
Adjusting the height of a projected image or changing projection angle
will result in Auto Keystone function to work to quickly correct the
vertical distortion. The "Keystone" screen will be displayed.
For operating the "Keystone" screen, see "Correcting Keystone Dis-
tortion" on page
Adjustable Tilt Foot
Adjustable Tilt
Foot Button
Ventilation (outlet)
4
LA
MP
ST
AT
US
PO
WE
R
SO
UR
CE
AU
TO
AD
J.
FO
CU
S
ON
/ST
AN
D B
Y
SE
LE
CT
CAUTION:
Do not use the tilt-foot for purposes other than originally intended.
Misuses such as using the tilt foot to carry or hang (from the wall or
ceiling) the projector can cause damage to the projector.
NOTE: The rear foot height can be adjusted up to 0.1 inch/3 mm (1 degree of angle).
Rotate the rear foot to the desired height in order to square the image on the projec-
tion surface, but the vertical distance from the bottom to the desk or floor should be
0.1” (3 mm) to make the projector horizontal on the flat surface.
CO
MPUT
ER
IN
AUD
IO IN
S-V
IDE
O IN
VIDE
O IN
LAM
P
ST
AT
US
POW
ER
SOU
RCE
AUT
O A
DJ.
FOC
US
ON/S
TAN
D B
Y
SELECT
PC
CO
NT
RO
L
Rear foot
Up
Down