Acoustic Energy LT35 - Manual (Page 56)

48
3. Loosen the two screws securing the lamp housing until the phillips screwdriver goes into a freewheeling
condition. The two screws are not removable.
Remove the lamp housing by holding it.
6. Maintenance
NOTE: There is an interlock on this case to prevent the risk of electrical shock. Do not attempt to circumvent this interlock.
4. Push the part labeled “PUSH” and insert a new lamp housing until the lamp housing is plugged into the
socket.
CAUTION
Do not use a lamp other than the NEC replacement lamp LT35LP (LT35) or LT30LP (LT30/LT25).
Order this from your NEC dealer.
Secure it in place with the two screws.
Be sure to tighten the screws.
5. Reattach the lamp cover.
6. Tighten the lamp cover screw.
Be sure to tighten the screw.
PUS H
PUSH
PUS
H
PUSH
Interlock