Use the select – Acoustic Energy LT35 User Manual

Page 26

Advertising
background image

18

EXIT

MENU

UP

PAGE

OFF

POWER

ON

PIC-MUTE

DOWN

FOCUS

ENTER

FOCUS

SELECT

FOCUS

SELECT

3. Projecting an Image (Basic Operation)

Note on Startup screen (Menu Language Select screen)

When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one
of the nine menu languages.

To select a menu language, follow these steps:

1. Use the SELECT

̆

or

̄

button to select one of the

nine languages from the menu.

2. Press the ENTER button to execute the selection.

After this has been done, you can proceed to the menu opera-
tion.
If you want, you can select the menu language later. (

→ [Lan-

guage] on page

40

)

NOTE: Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamp lighting
is stabilized.

When the [Lamp mode] is set to [Eco], the LAMP indicator will light green.

If one of the following things happens, the projector will not turn on.

• If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this

condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's internal
components to cool down.

• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.

• If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and

then turn on the power.

ENTER

EXIT

MENU

UP

PAGE

OFF

POWER

ON

PIC-MUTE

DOWN

FOCUS

Advertising
This manual is related to the following products: