Acoustic Energy LT35 - Manual (Page 33)

25
ᕥ Correcting Keystone Distortion Manually
You can also correct the vertical keystone distortion manually.
NOTE: Manual keystone correction is not available when there is no signal received by any input.
Adjust the keystone distortion manually in the following cases:
• To fine tune Keystone correction even after performing the [Auto Keystone] adjustment.
• When the menu setting for [Auto Keystone] is turned off
Adjusting with buttons on the cabinet
3. Projecting an Image (Basic Operation)
1. Press the SELECT ̆ or ̄ button with no
menus displayed.
The slide bar will be displayed for your adjust-
ment.
2. Press the EXIT button.
The slide bar will be closed.
Adjusting with the remote control
1. Press the MENU button.
The menu will be displayed.
LAMP
STATUS
POWER
SOURCE AUTO ADJ. FOCUS ON/STAND BY
SELECT
2. Use the SELECT ̄ button to select [Setup -
General] and then press the ENTER button.
3. Select the Keystone function.
Use the SELECT
̄
button to select [Keystone].