Canon PowerShot D30 User Manual
Page 37
Before Use
Basic Guide
Advanced Guide
Camera Basics
Using GPS
Functions
Auto Mode
Other Shooting
Modes
P Mode
Playback Mode
Setting Menu
Accessories
Appendix
Index
37
Before Use
Basic Guide
Advanced Guide
Camera Basics
Using GPS
Functions
Auto Mode
Other Shooting
Modes
P Mode
Playback Mode
Setting Menu
Accessories
Appendix
Index
Resize the subject and
recompose the shot as needed.
z
z
To resize the subject, repeat the
operations in step 4 (
However, note that the sound of camera
operations will be recorded. Note that
movies shot at zoom factors shown in
blue will look grainy.
z
z
When you recompose shots, the
focus, brightness, and colors will be
automatically adjusted.
Finish shooting.
z
z
Press the movie button again to stop
shooting. The camera beeps twice as
recording stops.
z
z
Recording will stop automatically when
the memory card becomes full.
Still Images/Movies
•
If the camera is turned on while the <
p> button is held down, the
camera will no longer sound. To activate sounds again, press the
<
n> button and choose [Mute] on the [3] tab, and then press
the <
q><r> buttons to choose [Off].
Still Images
•
A blinking [
] icon warns that images are more likely to be blurred
by camera shake. In this case, mount the camera on a tripod or take
other measures to keep it still.
•
If your shots are dark despite the flash firing, move closer to the
subject. For details on the flash range, see “Flash Range” (
•
The subject may be too close if the camera only beeps once when
you press the shutter button halfway. For details on the focusing
range (shooting range), see “Shooting Range” (
•
To reduce red-eye and to assist in focusing, the lamp may be
activated when shooting in low-light conditions.
•
A blinking [
h] icon displayed when you attempt to shoot indicates
that shooting is not possible until the flash has finished recharging.
Shooting can resume as soon as the flash is ready, so either press
the shutter button all the way down and wait, or release it and press
it again.
•
You can change how long images are displayed after shots (