Canon VB-C60 - Manual (Page 51)

2-9
Step 2 Connect the Camera to the Network
Init
ial S
e
tting and
Ins
ta
llati
o
n
of Cam
e
ra
Use of External Power Supply
An AC adapter, 12-VDC input or 24-VAC input can be used as an external power supply.
Connect the supplied power connector ( P. x) as shown in the figure below.
Use a 12-VDC or 24-VAC power supply insulated from 100 VAC.
12 VDC can be connected in a non-polar condition. Use the power supply within the following
voltage range.
24 VAC: Voltage fluctuation 24 VAC ± 10% or less
(50 or 60 Hz ± 0.5 Hz or less)
Current supply capacity per camera 1.0 A or more
12 VDC: Voltage fluctuation 12 VDC ± 10% or less
Current supply capacity per camera 1.5 A or more
* If a 12-VDC battery power supply is used, be sure to connect a resistor of 0.5 to 1.0 Ω/20 W
or more to the power line.
* Use double-insulated devices for the external power supply.
Recommended Power Cable of VB-C60 [Reference]
This completes the network connection.
Cable (AWG)
conductor size
(Φmm, Φinch)
#24
(0.52 mm)
(0.020inch)
#22
(0.65 mm)
(0.026inch)
#20
(0.82 mm)
(0.032inch)
#18
(1.03 mm)
(0.041inch)
#16
(1.30 mm)
(0.051inch)
Maximum cable length,
12 VDC (m, ft)
5
(16.4)
9
(29.5)
14
(45.9)
23
(75.4)
32
(105.0)
Maximum cable length,
24 VAC (m, ft)
11
(36.1)
18
(59.0)
29
(95.1)
46
(151.0)
64
(210.0)
Use a UL cable (UL-1015 or equivalent) for wiring 12 VDC or 24 VAC.
Screwdriver
Tightening torque:
0.2 N·m (1.77lbf·in) (max.)
Stripping length
approx. 4mm - 6mm
(0.16inch - 0.24inch)
Power Connector
(Supplied)