P.695 – Canon imagePROGRAF iPF8400S User Manual
Page 695
2
Press the OK button.
The Set./Adj. Menu is displayed.
3
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4
Press ▲ or ▼ to select AppleTalk, and then press the OK button.
5
Press ▲ or ▼ to select On, and then press the OK button.
6
Press the Menu button.
If you have changed any settings, a confirmation message is
displayed. In this case, press the OK button.
Important
•
Be sure to complete step 6. This will activate the values you have entered.
Note
•
By using RemoteUI, you can also specify the object name used for AppleTalk, as well as the printer zone name.
For details on RemoteUI, see "Using RemoteUI."
Configuring the Printer's AppleTalk Network Settings
Configuring the Printer's AppleTalk Network Settings
Follow the steps below to configure the AppleTalk network settings.
1
Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUI
page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
2
Select Administrator Mode and click Logon.
3
If a password has been set on the printer, enter the password.
4
Click Network in the Device Manager menu at left to display the Network page.
5
Click Edit in the upper-right corner of the AppleTalk group to display the Edit AppleTalk Protocol Settings
page.
6
Refer to the AppleTalk Settings Items table to complete the settings.
AppleTalk Settings Items
Item
Details
Default Setting
Phase
Type
Specify whether to use AppleTalk.
If you will use AppleTalk, choose Phase 2.
If you will not use AppleTalk, choose Disabled.
Disabled
Name (*1)
Specify the object name used by AppleTalk (in up to 31 single-byte or 15 double-byte characters).
However, do not use the following single-byte characters: @, *, :, and =.
Canon NB-18GB
(xxxxxx)
Zone (*2)
Specify the printer zone name, up to 31 single-byte characters.
*
iPF8400S
Configuring the Printer's AppleTalk Network Settings
Network Setting
Mac OS Settings
695