Avaya 1165E User Manual
Page 255
Appendix: Connecting the components
255
need to remove the IP Deskphone from the wall to adjust the lower
screws. When the lower screws are snug, install the IP Deskphone on
the mounting screws, and then tighten the top screws.
Method B: Attach a 15-cm (6-inch) CAT5e cable (not supplied),
position the stand over the mounting rivets, and slide the IP
Deskphone down the wall so that the rivets fit into the slots on the
stand.
9.
Replace the stand cover. Ensure that all cables are neatly routed and
press the stand cover into place until you hear a click.
10. Put the IP Deskphone in the wall-mount position. If you wall-mounted
your IP Deskphone, put it in the wall-mount position by holding the Tilt
Lever and pressing the IP Deskphone towards the base until the IP
Deskphone is parallel with the base. Release the Tilt Lever and
continue to push the IP Deskphone towards the base until you hear
an audible click. Ensure the IP Deskphone is securely locked in
position.