Electrolux EI23CS35KB - Manual (Page 39)

39 Before You Call
Temperatures Are Too Warm
Concern Cause Solution
Freezer/
Refrigerator
temperature is too
warm.
• Doors are opened too
frequently or too long.
• Door is slightly open.
• Warm air enters the refrigerator whenever the door is
opened. Open the door less often.
• See Problem section, Opening/Closing of Doors/Drawers.
Freezer
temperature is too
warm. Refrigerator
temperature is
satisfactory.
• Freezer control is set too
warm.
• Set freezer control to a colder setting. Allow 24 hours for
temperature to stabilize.
Refrigerator
temperature is
too warm. Freezer
temperature is
satisfactory.
• Refrigerator control is set
too warm.
• Set refrigerator control to a colder setting. Allow 24 hours
for temperature to stabilize.
Temperature in
the Meat Keeper
is too warm (some
models).
• Meat Keeper temperature
control is set too warm.
• Adjust Meat Keeper temperature control to a colder
setting.
Water/Moisture/Frost Inside Refrigerator
Concern Cause Solution
Moisture collects on
inside of refrigerator
walls.
• Weather is hot and humid.
• Door is slightly open.
• Door is opened too often or
too long.
• Open containers.
• The rate of frost buildup and internal sweating increases.
• See Problem section, Opening/Closing of Doors/Drawers.
• Open door less often to allow internal temperature to stabilize.
• Keep containers covered.
Water collects on
bottom side of
drawer cover.
• Vegetables contain and give
off moisture.
• Moisture on the bottom side of the cover is not unusual.
• Move humidity control (some models) to lower setting.
Moisture collects in
bottom of drawer.
• Washed vegetables and fruit
drain while in the drawer.
• Fruits and vegetables are kept
past their prime
• Dry items before putting them in the drawer. Water collecting in
bottom of drawer is normal.
• Routinely clean out old fruits and vegetables especially if they
begin to break down.
Moisture collects on
outside of refrigerator
or between doors.
• Weather is humid.
• Door is slightly open,
causing cold air from inside
refrigerator to meet warm air
from outside.
• This is normal in humid weather. When humidity is lower, the
moisture should disappear.
• See Problem section, Opening/Closing of Doors/Drawers.
Perfect Temp Drawer (some models)
Concern Cause Solution
Display does not
illuminate or shows
“CE”.
• Connector not connected or
loose.
• Remove pan and insure connector is fully engaged. (See
Storage Features section)
Display shows “LOC”
when buttons are
pressed.
• Drawer in control lock mode. • Press and hold control lock button for three seconds to take
drawer out of control lock mode. (See Storage Features
section)