Before you call – Electrolux EI23CS35KB User Manual

Page 40

Advertising
background image

40

Before You Call

Automatic Ice Maker

Concern

Cause

Solution

Ice maker is not

making any ice.

• Ice maker power switch

is Off.

• Water supply is not

connected to refrigerator.

• Household water line

valve is not open.

• Freezer is not cold

enough.

• Household water line to

the refrigerator is kinked.

• Valve on cold water pipe

is clogged or restricted by

foreign material. If valve is

of the self-piercing type,

it may not have created

a sufficiently sized hole

in tube for water to pass

through.

• Check to see if the water

dispenser is dispensing

water.

• Water filter is not

completely seated.

• Turn on power switch.

• Connect water supply (see Installation Instructions).

• Turn on household water line valve.

• See Problem section, Temperatures Are Too Warm.

• Unkink the water line. If it is a copper line, it should be

replaced because of possible leaks at the kink. A copper

line should be coiled behind the unit to avoid kinking.

• Turn off household water line valve. Remove valve. Ensure

that valve is not a self-piercing valve. Clean valve. Replace

valve if necessary.

• If not, the ice & water filter cartridge is clogged or

restricted, and must be replaced.

• Push firmly until the water filter snaps into place (you

should hear two clicks).

Ice maker is not

making enough ice.

• Ice maker is producing

less ice than you expect.

• Freezer is not cold

enough.

• Household water line

valve is not completely

open.

• Check to see if water

dispenser is dispensing

slower than normal.

• Freezer control is set too

warm.

• Ice maker should produce approximately 4-5 pounds

of ice every 24 hours. Fast Ice should produce up to 6

pounds of ice every 24 hours.

• See Problem section, Temperatures Are Too Warm.

• Turn on household water line valve.

• If it is, replace the ice & water filter cartridge.

• Set freezer control to colder setting to improve

performance of the ice maker. Allow 24 hours for

temperature to stabilize.

Ice maker will not

stop making ice.

• Ice maker wire signal arm

is being held down by

some item in the freezer.

• Move item and release wire signal arm. Remove any ice

cubes frozen together over wire signal arm.

Ice maker is not

separating the ice

cubes.

• Ice cubes are not being

used frequently enough.

• Ice cubes are hollow or

smaller than normal.

• Remove and shake ice bin to separate cubes.

• The ice & water filter cartridge may be clogged. Replace

filter cartridge.

Ice has bad odor

and taste.

• Ice has picked up odor

or flavor from strong food

stored in refrigerator or

freezer.

• Ice not used frequently

enough.

• Cover foods tightly. Discard stale ice. Ice maker will

produce fresh supply.

• Discard stale ice.

Advertising
This manual is related to the following products: