Changing the water and air filters, Water filter – Electrolux EW28BS85KS User Manual

Page 30

Advertising
background image

30

Changing The Water and Air Filters

Your refrigerator is equipped with separate water and

air filtering systems. The water filter system filters all

dispensed drinking water, as well as the water used to

produce ice. The air filter removes odors and impurities

from the refrigerator compartment.

Replacement

Water Filter

Remove Two

Protective Caps

Push Water Filter Button

Water Filter

Button

Water Filter

Cartridge

NOTE

The control panel includes controls to monitor the

status of your water and air filters. See the Controls

section for more information.

About your advanced water filter

The

PureAdvantage

TM

NGFC 2000 ice and

water filter system is tested and certified by

NSF International to NSF/ANSI Standards 42

and 53 for the reduction of claims specified on

the performance data sheet.

Water filter

The water filter is located at the lower left side of the

fresh food compartment.

Replacing your PureAdvantage

TM

water filter

In general, you should change the water filter every six

months to ensure the highest possible water quality. The

Water Filter Status light on the Touch Panel prompts

you to replace the filter after a standard amount of water

(400 gallons)

has flowed through the system.

If your refrigerator has not been used for a period of

time (during moving for example), change the filter

before reinstalling the refrigerator.

It is not necessary to turn the water supply off to

change the filter. Be ready to wipe up any small

amounts of water released during the filter replacement.

1 Turn

Off the ice maker on the control panel.

2 Push the filter release button above the cartridge

to disconnect it.

3 Slide the old water filter cartridge straight out of

the housing and discard it.

4 Unpack the new filter cartridge and remove the

two protective caps covering the inlet and exit of

the filter. Slide the filter gently into the housing

until it stops against the snap-in connector at the

back of the housing.

Do not use with water that is microbiologically unsafe or of

unknown quality without adequate disinfection before or after

the system. Systems certified for cyst reduction may be used

on disinfected waters that may contain filterable cysts.

• Rated Capacity - 400 gallons for

PureAdvantage

TM

ice and water filter

• Rated service flow - .5 gallons per minute
• Maximum Rated Pressure - 100 pounds per

square inch

• Recommended Minimum Operating Pressure: 30

pounds per square inch

• Operating Temp.: Min. 33° F, Max. 100° F

5 Push firmly until the cartridge snaps into

place (you should hear two clicks). When fully

engaged, the front of the filter cartridge should be

flush with the filter release button.

Reinstall Water Filter

Push-In

Until

Two Clicks

6 Turn

On the ice maker at the control panel.

7 Press a drinking glass against the water

dispenser while checking for any leaks at the filter

housing. Spurts and sputters may occur as the

system purges air out of the dispenser system.

8 Prime the water supply system as described

previously.

9 Press and hold the Filter Status button on the control

panel for three seconds. When the display changes

from

Replace to Good, the status has been reset.

Advertising
This manual is related to the following products: