Electrolux EW28BS85KS - Manual (Page 33)

33 Care and Cleaning
Care and cleaning tips
Part Cleaning Agents Tips and Precautions
Interior & Door
Liners
• Soap and water
• Baking soda and
water
• Use two tablespoons of baking soda in one quart of warm water.
• Be sure to wring excess water out of sponge or cloth before cleaning around controls, light
bulb or any electrical part.
Door Gaskets • Soap and water • Wipe gaskets with a clean soft cloth.
Drawers & Bins • Soap and water • Use a soft cloth to clean drawer runners and tracks.
• Do not wash any removable items (bins, drawers, etc.) in dishwasher.
Glass Shelves • Soap and water
• Glass cleaner
• Mild liquid
sprays
• Allow glass to warm to room temperature before immersing in warm water.
Toe Grille • Soap and water
• Mild liquid
sprays
• Vacuum
• Remove toe grille (see Installation Instructions).
• Vacuum both sides and wipe with sudsy cloth or sponge. Rinse and dry.
Exterior &
Handles
• Soap and water
• Non abrasive
glass cleaner
• Do not use commercial household cleaners containing ammonia, bleach or alcohol to clean
handles.
• Use a soft cloth to clean smooth handles.
• Do not use a dry cloth to clean smooth doors.
Exterior &
Handles
(Stainless Steel
Models Only)
• Soap and water
• Stainless steel
cleaners
• Never use CHLORIDE or cleaners with bleach to clean stainless steel.
• Clean stainless steel front and handles with non-abrasive soapy water and a dishcloth.
Rinse with clean water and a soft cloth.
• Use a non-abrasive stainless steel cleaner. These cleaners can be purchased at most home
improvement or major department stores. Always follow manufacturer’s instruction. Do not
use household cleaners containing ammonia or bleach.
• NOTE: Always clean, wipe and dry with grain to prevent scratching.
• Wash the rest of the cabinet with warm water and mild liquid detergent. Rinse well and
wipe dry with a clean soft cloth.
Ice Chute Extension
The ice chute extension is
designed to better direct ice
flow into containers.
Push Upward Until The
Extension Snaps In Place
Pull Down
Press Here
Firmly
Removing the Ice Chute Extension For
Cleaning
1 Turn the
refrigerator
off using the
button on
the control
panel (refer
to Owner’s
Manual).
2 Press inward
firmly on the
front of the chute
and pull down.
3 Turn your refrigerator back on.
Installing the Ice Chute Extension
1 Turn the refrigerator
off using the button
on the control panel
(refer to Owner’s
Manual).
2 Align the extension
with the ice chute so
that the snap clips
are just inside the
front edge of the
chute.
3 Push upward until
the extension snaps into place.
4 Turn your refrigerator back on.