Configuring the ip phones – Aastra Telecom SIP 57I User Manual
Page 175
Global SIP Settings
41-001160-00, Release 2.1, Rev 04
4-51
Configuring Network and Session Initiation Protocol (SIP) Features
Configuring the IP Phones
IP Phone UI
Step Action
1
Press
on the phone to enter the Options List.
2
Select Administrator Menu.
3
Enter your Administrator password.
Note: The IP Phones accept numeric passwords only.
4
Select SIP Settings.
Configuring Proxy IP and Proxy Port
5
Select Proxy IP/Port.
6
Enter an IP address or fully qualified host name in the Proxy Server field. Default is 0.0.0.0.
7
Enter a Proxy Port number in the Proxy Port field for accessing the SIP proxy server.
Default is 0.
8
Press Done to save the changes.
Configuring Registrar IP and Registrar Port
9
Select Registrar IP/Port.
10
Enter an IP address or fully qualified host name in the Registrar Server field. Default is 0.0.0.0.
A global value of 0.0.0.0 disables registration. However, the phone is still active and you can dial
using username@ip address of the phone.
If the Registrar IP address is set to 0.0.0.0 for a per-line basis (i.e, line 1, line 2, etc.), then the
register request is not sent, the "No Service" message does not display, and the message waiting
indicator (MWI) does not come on.
11
Enter a Registrar Port number in the Registrar Port field for accessing the SIP registrar server.
Default is 0.
12
Press Done to save the changes.
Enabling/Disabling the Use of the Registrar Server
13
Select SIP Register.
14
Press Change to set Register to "Yes" (enable) or "No" (disable). Default is “Yes”.
This parameter enables/disables the IP phone to register on the network.
15
Press Done to save the changes.