Aastra Telecom SIP 57I - Manual (Page 161)

Network Settings
41-001160-00, Release 2.1, Rev 04 4-37
Configuring Network and Session Initiation Protocol (SIP) Features
Configuring the IP Phones Configuring VLAN (optional)
Use the following procedures to configure VLAN on the IP phone.
Note: VLAN is disabled by default. When you enable VLAN, the IP
phones use the default settings for each VLAN parameter. You can
change the default settings if required using the following procedure.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Virtual Local
Area Network (VLAN) Settings” on page A-26.
IP Phone UI
Step Action
1 Press on the phone to enter the Options List.
2 Select Administrator Menu.
3 Enter your Administrator password.
Note: The IP Phones accept numeric passwords only.
4 Select Network Settings.
5 Select VLAN Settings.
To globally enable/disable VLAN and set priority for non-IP packets:
6 Select VLAN Enable.
7 Press Change to set VLAN Enable to “Yes” to enable or “No” to disable. Default is “No”.
8 Press Done to save the changes.
9 Select Phone VLAN.
10 Select VLAN Priority.
11 Select Other and enter a non-IP priority value from 0 to 7 for non-IP packets.
Default for this field is 5.
12 Press Done (3 times) to return to the VLAN Settings menu.