Park calls/pick up parked calls, Reference, Park calls/pick up parked calls -35 – Aastra Telecom SIP 57I User Manual
Page 245: Park calls/pick up parked, Calls, Operational ip phone features
Operational Features
41-001160-00, Release 2.1, Rev 04
5-35
Configuring Operational Features
Operational IP Phone Features
Park Calls/Pick Up Parked Calls
The IP phones (including the 57i CT handset) have a park and pickup call feature
that allows you to park a call and pickup a call when required. There are two ways
a user or administrator can configure this feature:
•
Using a static configuration (globally configures park and pickup)
•
Using a programmable configuration
The IP phones support the Park/Pickup feature on the Asterisk, BroadWorks,
Sylantro, and ININ PBX servers.
The following paragraph describes the park and pickup static configuration on the
IP phones.
Reference
For information on configuring the park and pickup programmable configuration
(using a key), see
Park/Pickup Static Configuration (55i, 57i, 57i CT only)
Using the static method of configuring park and pickup configures these features
on a global basis for all IP phones connected in the network. You can use the
configuration files or the Aastra Web UI to configure a park/pickup static
configuration.
In the configuration files, you use the following parameters to statically configure
park/pickup:
•
sprecode:
•
pickupsprecode:
Note:
The IP phones accept both methods of configuration. However, to
avoid redundancy, Aastra Telecom recommends you configure either a
static configuration or a programmable configuration.