Aviom A-16CS - Manual (Page 30)

Aviom A-16R and A-16CS User Guide
20
audio mix.
Set the M
ASTER
V
OLUME
knob on the Personal Mixer to a low setting,
about 9 or 10 o’clock should be safe. Send audio into the system; this
could be the band playing live or audio from a tape deck or other
multi-track audio device. Raise the levels to a comfortable level after
you have audio playing through the system.
Mixing
Start creating a monitor mix by selecting the first Channel you want to
hear.
Set the Channel Volume
Follow these steps:
• Press the desired Channel button — its upper red LED
will light.
• Turn the V
OLUME
knob clockwise to raise the volume
of the selected Channel until you hear it in the monitor
(speakers, headphones, in-ear monitors, etc.). You
should see the volume changes you’re making reflected
in the Volume LED indicators. More LEDs lit indicates
higher volume.
There are twenty-four visible volume steps available in the Volume
LEDs. Each LED lights at two levels—one at half brightness, the other
at full brightness.
Set the Pan Location
The procedure for setting the pan position for a Channel is similar.
Once a Channel is selected, you can turn the P
AN
knob left or right to
move the Channel in the stereo field. Your changes will be reflected in
the Pan LEDs. Changes will be heard immediately in any speakers, in-
ear monitors (IEM) or headphones connected to your Personal Mixer.
Note: If you have connected the output of the Personal Mixer
to a mono audio system or speaker, pan position is
irrelevant. Leave all Channels panned to the center.
A Channel is heard in the center of the stereo field when only the
center (green) LED is lit. As you turn the P
AN
knob, the Pan LEDs will
light in various combinations to indicate the pan position.