Aviom A-16CS - Manual (Page 74)

64
Aviom A-16R and A-16CS User Guide
that the even-numbered channel (the right side of the
pair) will inherit the characteristics of the odd-num-
bered channel (left side of the pair).
Problem: When editing a Group that contains a large number of
Channels, it seems like all of the LEDs are pulsing.
Possible Solutions
• This is a normal effect of the current-limiting circuit
and is not an indication of a problem.
Problem: Don’t know if a Preset was saved.
Possible Solutions:
• When saving a Preset, make sure that the R
ECALL
and
G
ROUP
buttons are both held down before pressing a
memory location button. The Preset is saved when you
release your finger from the memory location button.
When a Preset has been saved correctly, you will see all
sixteen Channel LEDs flash momentarily to confirm
the save operation.
Problem: In Group mode, can’t select a new Channel.
Possible Solutions:
• If you already have three Groups defined and attempt
to select a new Channel that is not part of an existing
Group, the button press is ignored. This happens when
you are trying to create a new Group which would
exceed the limit of three Groups per Preset. Edit or
delete an existing Group to continue.
Problem: Nothing happens when editing from the front panel of
the A-16R. Or, nothing happens when trying to edit the A-16R remotely
using an A-16CS Control Surface.
Possible Solutions:
• The switch on the right side of the rack mounted A-16R
labelled R
EMOTE
/L
OCAL
determines which device is
active for editing.
• When using an A-16CS, make sure that the A-Control
cable is connected to the A-Control jack found on the
rear panel of the A-16R.
Note that only one device can edit an A-16R at a time.