Aviom A-16CS - Manual (Page 73)

63
necessary.
Problem: The A-Net LED is on, but there is no sound
Possible Solutions:
• The A-Net Active LED indicates that the input to the
receiving device is properly connected to another
A-Net device. It does not indicate that all devices in a
system are properly configured, however. If you have
two Personal Mixers connected together, the second
Personal Mixer’s A-Net LED will light because the first
Personal Mixer is correctly connected to it. Check that
each device in the chain has a Category 5 cable plugged
into it.
• Check that the A-Net cables are connected in the
correct order when using daisy-chain connections.
The Cat-5 cable connected to the first Personal Mixer
should be connected to the A-Net In jack. The next
device is connected from the Out on the first device to
the In on the next.
Problem: A Preset was saved with a stereo link active but when the
Preset is recalled the channels are mono. (Or, a Preset was saved with
mono channels, but on recall the Channels are linked.)
Possible Solutions:
• The status of the stereo link is set by the front panel
Link switches on the A-Net input module (or the DIP
switches on the Y1 card). If a Preset is recalled and the
position of the Link switch is different from when the
Preset was saved, the Preset will be adjusted to agree
with the current hardware settings on the A-Net input
module. If this happens, simply change the position
of the Link switch on the A-Net input module. Your
current mix will be updated immediately.
Problem: A Channel was assigned to one Group and now it is
suddenly part of a different Group.
Possible Solutions:
• When you link a stereo Channel pair with the Link
switch on the A-Net input module after a Group has
been created, it is possible that channel characteristics
could change. This includes the volume, pan, mute
status, and Group assignment. The rule to remember is