LG LTC22350SW - Manual (Page 12)

12
HOW TO REVERSE AND INSTALL THE REFRIGERATOR DOORS
You may find it more convenient to have the doors converted from the left opening type (factory installed) to the right
opening type. Directions refer to the right side as the side on your right as you face the unit.
TOOLS YOU MIGHT NEED OR USE
10 mm
13/32 in
3/8 in
Hex Socket Wrench Phillips Screwdriver No. 2 Flat Head Screwdriver
WARNING
ELECTRICAL SHOCK HAZARD
Before you begin, either unplug the refrigerator or
turn off the power at the circuit breaker or fuse box.
Remove food and any door rack from the refrigerator.
Failure to do so could result in death or serious injury.
1. Reversing Freezer Door
• Gently pry off the top hinge cover with a flat head
screwdriver and remove it (See Figure 1).
• Using 10 mm or 13/32 inch socket wrench, remove
the three bolts and lift off the top hinge (Figure 2).
Set parts aside.
• Lift up door slightly and remove it (See Figure 3).
• Turn freezer door upside down on a non scratch surface
and loosen the screw to remove door closer (stop) and
hinge pin insert. (Figure 4).
• Move the hinge bracket to the other side of the door
(keeping the same orientation) and move the hinge
pin insert into the hole on the left side of the bracket
(See Figure 5).
• Reverse door closer (stop) by flipping over (Figure 6),
place on top of hinge bracket and tighten both down
with the screw.
REFRIGERATOR INSTALLATION REFRIGERATOR INSTALLATION
Fig. 1
Door Closer (Stop)
Fig. 4
Fig. 2
Top Hinge
Hinge Pin Insert
Hinge Bracket
Fig. 5
Fig. 3