LG LTC22350SW - Manual (Page 15)

15
• With flat-head screwdriver, carefully pry off and
remove the cover over the screw holes on the left side
of refrigerator housing (Figure 20).
• Remove the outer lower Decorative Screw from
housing at area between freezer and refrigerator
doors (See Figure 21). (You will need this hole for the
Middle Hinge Bracket).
• Following illustration, flip the Middle Hinge Bracket
(Flange will now be on top) and position on left side of
refrigerator and re-attach with two bolts and a Phillips
screw (Figure 22).
• Place refrigerator door down over pin on bottom
hinge.
(See Figure 22).
• Place washer between refrigerator door and middle
hinge and re-attach Hinge Pin to Hinge Bracket with
1/4 inch socket wrench.
NOTE: Bracket has been flipped, but Hinge Pin stays in
the same orientation with its hexagonal end facing
upward.
• Place Decorative Screw into outer hole on right side of
housing (Figure 23).
• Attach cover on the right side. Cover is force-fitted
3. Reattaching Freezer Door
• Put freezer door down over the Hinge Pin on the
Middle Hinge Pin Bracket (See Figure 24).
• Place Upper Hinge’s Pin in the top of freezer door
and line up the Upper Hinge with holes in top of
refrigerator. Use the three bolts to replace Hinge
(Figure 25).
• Tighten bolts. Force-fit Top Hinge Cover over Top
Hinge (See Figure 26).
REFRIGERATOR INSTALLATION
Hinge
Pin
Insert
Fig. 20
Fig. 23
Decorative
Screw
Flange
Middle Hinge
Bracket
Fig. 22
Fig. 25
Fig. 26
Fig. 24
Fig. 21
Decorative
Bolt
Hinge
Pin