LG LTC22350SW - Manual (Page 14)

14
• At this point, remove the Decorative Bolt on bottom on
refrigerator housing from the left side of refrigerator
(See Figure 14). You will need this hole for the Bottom
Hinge.
• Move the Bottom Hinge to the left side of housing
keeping the same orientation, and reattach with three
bolts (Figure 15). Now move decorative bolt to hole on
lower right side of housing.
• Turn refrigerator door upside down on a non-
scratching surface.
• With door upside down, loosen the 2 screws and
remove the door closer (stop) (See Figure 16), then
loosen the other two screws to remove the bottom
Hinge Pin Insert Bracket with Hinge Pin Insert (Figure
17).
NOTE: The Refrigerator door closer (stop) is not used on
all models. The model you have may not include this
part.
• Take out the Hinge Pin Insert and move the Bracket
to the other side of the door, keeping the same
orientation (See Figure 17).
• Place Hinge Pin Insert into the left side of the bracket,
tighten Hinge Pin Bracket to door (Figure 18).
• Take Door Closer/stop and flip (See Figure 19). Line
up screw holes and mount on left side of door bottom
with the two screws. Turn door upright. It is now ready
for reattaching.
REFRIGERATOR INSTALLATION REFRIGERATOR INSTALLATION
Fig. 15
Fig. 14
Fig. 16
Door Closer (Stop)
Fig. 17
Hinge Pin Bracket Hinge
Pin
Insert
Hinge Pin
Bracket
Hinge
Pin
Insert
Fig. 18
Fig. 19
Door Closer (Stop)
Decorative
Bolt
Fig. 13