LG BX286 - Manual (Page 16)

6
English
Installation
Powering Off the Projector
1. Press the “POWER” to turn off the projector lamp, you will
see a message as below on the on-screen display.
2.
Press the “POWER” again to confirm.
3. The cooling fan continues to operate for about 60 seconds for
cooling cycle and the POWER LED will flash green. When
the POWER LED flashes orange, the projector has entered
standby mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and has
enter standby mode.
Once in standby mode, simply press “POWER” to restart the
projector.
4. Disconnect the power cable from the electrical outlet and the
projector.
5. Do not turn on the projector immediately following a power
off procedure.