Aastra Telecom 800 - Manual (Page 128)

Frequently Asked Questions DECT
126
14.2 DECT
Question: Is it possible to increase the time for the enrolment procedure?
You must manually enter the IPEI of the DECT device in the Configurator. The
enrolment time is then increased to one hour (Telephony: Devices: DECT Phones
menu).
Question: Another manufacturer’s DECT device is not functioning.
Check whether the DECT device supports the DECT GAP standard. In the
Configurator, also make sure GAP is set for this DECT device (Telephony:
Devices: DECT Phones menu).
14.3 LAN
Question: Why is it not possible to establish a network connection with the
Aastra 800?
Check whether the LEDs for the switch and the PC’s network card are indicating a
connection.
To check whether there is a network connection with your Aastra 800, enter the
“ping IP address” command in “Run” in the Windows Start menu (e.g. ping
192.168.99.254).
Question: How can I determine the IP address of the Aastra 800?
To find out what the IP address is, enter the code number
*182 on one of
the connected system telephones.
The code-number procedure *183 also displays the network mask.
Question: The network connection is functioning, but nothing is displayed in
the browser.
Enter the complete IP address of the Aastra 800 along with the protocol identifier,
for example http://192.168.99.254/.
Check whether the browser has been configured for connection through a proxy
server. If so, deactivate the “Connect through proxy server” setting.