Aiwa HT-DV90 - Manual (Page 16)

16
ENGLISH
DVDs:
Playback starts automatically
.
If the menu is displayed, see “USING THE MENU”, below .
To switch the number between title and chapter , press
SHIFT+TITLE/CHP. With each press, title or chapter is
displayed alternately .
Audio CDs function:
6 If playback does not start automatically, press c
to start playback.
To play back DVDs recorded in Dolby Digital or DTS sound
See section “SURROUND PLA YBACK” (pages 24-26).
To play back an MP3 disc
Menu screen (SMAR T NAVI) appears on the TV screen after the
disc is loaded.
1. Press
i , k , j or l to select PLA Y MODE.
SHIFT+PRGM, RANDOM or REPEAT is also available.
For the programed playback, see page 20.
2. Press i , k , j or l to select the folder and press ENTER.
3. Press i , k , j or l to select the file.
4. Press c to start playback.
When the play mode is program, the program file is added
each time
c is pressed. To start playback, press s and then
press c .
• 0-9 is also available to select the file up to 2 digit number .
The file with cannot be played back since it cannot be read
properly .
NOTE
• When loading an 8-cm (3-inch) disc, put it onto the inner circle
of the slot.
• Do not place more than one disc.
• Do not tilt the unit with disc loaded. Doing so may cause
malfunctions.
USING THE MENU
DVDs with the menu function may automatically display the menu
screen when the disc is loaded. Operate the menu as follows.
DVDs
1 Press i , k , j , or l to select your desired
program.
2 Press ENTER to begin playback.
To manually display the menu
Press MENU or TOP MENU during playback or stop.
NOTE
• The disc continues to spin as long as the menu is displayed.
• The contents and operation of the software specific menu vary
with the disc. Follow the instructions on the disc and on the
menu screen.
STOPPING AND PAUSING
To stop playback
Press s .
Playback stops. For DVDs, “RESUME” appears and the unit
remembers the point at which playback stopped.
To resume playback from the point where it stopped (DVD
only)
Press c .
Playback starts where it last stopped (Resume function).
To clear the point to be resumed (DVD only)
Press s again during stop.
“ST OP” appears in the TV display . The resume memory is cleared,
and playback starts at the beginning of the disc when
c is
pressed.
Last scene function (DVD only)
If the disc is taken out or s is pressed to clear the resume
memory , resume function is still ef fective (up to 7 discs). Next
time the disc is loaded, “PRESS PLA Y TO RESUME PLAY”
appears on the TV screen. To resume playback, press c while
the message is displayed. If a new disc is loaded when the
memory is full, the resume data for the oldest disc is erased.
Last screen function may not work with some discs.
To pause playback
Press a .
To resume playback, press c .
NOTE
• DVD playback is resumed with the subtitle and audio language
setting at the time it was stopped, regardless of possible later
changes.
• During stop of MP3 disc or resume of DVD, the disc is still
spinning.
Total number of tracks
Title number Elapsed time of current title
Total playing time