Asus V2-PE3 - Manual (Page 80)

5-18 Chapter 5: BIOS setup
Onboard LAN Device [Enabled]
Allows you to enable or disable the onboard LAN device support.
Configuration options: [Disabled] [Enabled]
Onboard LAN Boot ROM [Disabled]
Allows you to enable or disable the boot ROM of the onboard LAN chip.
Configuration options: [Enabled] [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
Allows you to set the Serial Port 1 base address.
Configuration options: [Disabled] [3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4]
[2E8/IRQ3] [Auto]
Onboard Serial Port 2 [2F8/IRQ3]
Allows you to set the Serial Port 2 base address.
Configuration options: [Disabled] [3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4]
[2E8/IRQ3] [Auto]
Onboard Parallel Port [378/IRQ7]
Allows you to set the base address of the onboard parallel port connector.
Configuration options: [Disabled] [378/IRQ7] [278/IRQ5] [3BC/IRQ7]
SuperIO Device
This sub-menu allows you to set the configurations for SuperIO devices.
Select an item then press <Enter> to edit.
Phoenix - Award BIOS CMOS Setup Utility
SuperIO Device
Select Menu
Item Specific Help
Select Serial Port1
base address.
: Move Enter:Select +/-/PU/PD:Value F10:Save&Exit ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F9: Optimized Defaults
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial POrt 2 [2F8/IRQ3]
UART Mode Select [Normal]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [ECP]
ECP Mode Use DMA [3]